Load Calculation
Manual J heat-loss math prevents the classic mistake of oversizing based on the old boiler.
High-Efficiency Boiler Installation That Lasts
A properly installed condensing boiler quietly delivers even, comfortable warmth for two decades. We size the load, plan the near-boiler piping, and commission the burner so you get every BTU you paid for.
Correct sizing, correct piping, correct commissioning
Boilers are unforgiving of shortcuts. We follow the near-boiler piping diagram from the manufacturer, size the primary/secondary loops correctly, and confirm combustion before we leave.
Efficiency Tier
80% AFUE cast-iron, 95%+ AFUE wall-hung, or fully modulating condensing — matched to your goals.
Combi Units
Space and cost savings with a combi boiler that heats water and radiators from one appliance.
Primary/Secondary
Modern near-boiler piping prevents flow issues in multi-zone systems.
Direct Vent
PVC sidewall intake and exhaust for condensing units — no chimney required.
Smart Controls
Outdoor reset control and Wi-Fi thermostats included to squeeze out every point of efficiency.
Signs your boiler is at end of life
Any two of these mean replacement usually costs less than another season of repairs.
25+ Years Old Leaking Block Cracked Section Constant Repairs High Fuel Bills Cold Rooms
Decisions to make before we quote
Getting these right up front makes for a cleaner install and a longer-lasting system.
01
Combi or Boiler + Tank
A combi saves space and cost but limits simultaneous hot-water use. If you have three showers running at once, a boiler with an indirect tank is better.
02
Condensing vs Cast-Iron
Condensing boilers are 95%+ AFUE but need PVC venting and condensate drain. Cast-iron is cheaper up front and simpler to service.
03
Add Zoning
If you're already opening the walls, splitting the house into zones improves comfort and cuts fuel use significantly.
04
Fuel Conversion
Switching from oil to gas during boiler replacement typically pays back in 3–5 years and eliminates the fuel tank.
Cast-Iron vs Wall-Hung Condensing
Cast-Iron 85% AFUE
Wall-Hung 95%+ AFUE
- Best For
Simple replacements keeping the chimney flue.
Homeowners wanting lowest fuel bills and quiet operation.
- Venting
Existing chimney.
Direct-vent PVC through the wall.
- Footprint
Full floor-standing unit.
Wall-hung, frees up floor space.
- Fuel Bills
Baseline usage.
20–30% lower fuel use with modulation.
- Rebates
Basic utility rebate.
Federal 25C tax credit + PECO rebate available.
Swipe to compare →
Boiler installs across the region
Radiator conversions, combi retrofits and whole-house replacements — installed daily.
Philadelphia
South Philly, Center City, Northeast and Northwest — every rowhome layout.
Bucks County
Newtown, Yardley, Doylestown and Feasterville.
Montgomery County
Cheltenham, Elkins Park, Ambler and Jenkintown.
Delaware County
Havertown, Media, Springfield and Broomall.
A+ Rated
Free in-home boiler quote.
We measure the heat loss, walk the piping, and hand you a written proposal on the spot.
Financing available. Ask about promotions and manufacturer rebates that stack with the federal 25C tax credit.
Same-Day Response
Fast dispatch across Philly, Bucks, Montgomery and Delaware counties.
Licensed Technicians
EPA-certified pros who explain the work before we start.
A+ BBB Rated
Transparent pricing and honest recommendations, every visit.
Upfront Pricing
Flat-rate quotes — no surprises once the job begins.