Hot-Surface Igniter
Cracked or worn igniter replaced — the #1 no-heat call every winter.
Furnace Repair That's Fast, Safe and Guaranteed
A gas furnace has combustion, high voltage and moving parts — three good reasons not to guess. Our NATE-certified techs test flame signal, gas pressure and CO on every repair so you're not just warm, you're safe.
Repairs on every make and model
Whether it's a 20-year-old Trane 80% or a brand-new modulating Carrier Infinity, we've been inside it. Every truck stocks the most common ignition, control and blower components.
Flame Sensor Cleaning
Oxidized flame rods scrubbed and re-seated so the burner stays lit through a cycle.
Draft Inducer Motor
Failed pressure switches and inducer motors replaced with OEM parts.
Gas Valve Replacement
Stuck or leaking gas valves swapped and pressure-tested to manifold spec.
Control Board
Fault-code diagnosis and integrated furnace control board replacement.
Blower Motor & Wheel
Seized bearings, failed ECMs and out-of-balance wheels rebuilt or replaced.
Signs your furnace needs repair
These symptoms almost always get worse — and more expensive — the longer you wait.
Won't Ignite Blowing Cold Short Cycles Yellow Flame Loud Bang On Startup Higher Gas Bill
Two-minute checks that may save the trip
Try these before booking — you might be back to warm without a service call.
01
Reset the Thermostat
Confirm Heat mode, Auto fan, and setpoint at least 3°F above room temp. Replace batteries if the screen is dim.
02
Cycle the Breaker & Switch
Flip the furnace disconnect and its breaker fully off, wait 30 seconds, then back on. Many lockouts clear this way.
03
Replace the Filter
A clogged filter causes the high-limit safety to shut the burner off. Fresh filter, wait 20 minutes, try again.
04
Check the Gas Valve
The yellow handle at the furnace should be inline with the gas pipe. If it was closed for AC season, open it before restart.
When repair still makes sense
Repair
Replace
- Age
Under 15 years, routine maintenance history.
18–25 years old, out of warranty.
- Repair Cost
Under $500 for a routine fix.
$1,500+ on a system with prior issues.
- Heat Exchanger
No cracks, CO reading clean.
Cracked heat exchanger — replace for safety.
- Efficiency
80–95% AFUE still meeting spec.
65–70% AFUE — upgrade cuts bills 25%+.
- Comfort
Even heat, quiet operation.
Cold rooms, loud startup, dusty airflow.
Swipe to compare →
Furnace service across the region
Emergency dispatch to every Philly neighborhood plus Bucks, Montgomery and Delaware counties.
Philadelphia
Rowhomes to twins — narrow mechanical closets are our specialty.
Bucks County
Feasterville, Langhorne, Newtown, Warminster and Doylestown.
Montgomery County
Willow Grove, Abington, Ambler, Cheltenham and Elkins Park.
Delaware County
Havertown, Media, Broomall and Springfield.
A+ Rated
Get your furnace running today.
Live dispatch 24/7 during heating season — no answering machines.
Every repair includes combustion analysis, CO test and a written report. Warranty on parts and labor.
Same-Day Response
Fast dispatch across Philly, Bucks, Montgomery and Delaware counties.
Licensed Technicians
EPA-certified pros who explain the work before we start.
A+ BBB Rated
Transparent pricing and honest recommendations, every visit.
Upfront Pricing
Flat-rate quotes — no surprises once the job begins.